WarmHeat UK Logo

m: 07710 449159

t: 0161 818 4790

email: warmheatuk@mail.com


  • 01
  • bootstrap image slider
  • 03

Dual Overlay System

Most stable overlay system for all types of floor heating.

Heat Pak Dual Overlay must NOT be used in bathrooms, wetrooms, en-suites or any other wet areas as they will expand upon contact with moisture. If installing carpet or vinyl in any of these areas, you must use an underfloor heating mat with self-levelling compound. Please speak to technical for further details.

Foam Tiles

Heat-Pak® is a free floating sub-floor specially designed for installation over all types of floor heating systems. This innovative system provides a very smooth, stable base onto which all kinds of floor-coverings can be laid directly.

The twin layers of Heat-Pak® panels utilise an overlap joint configuration to produce a seamless surface and prevent lines from ghosting through shiny floor finishes. Heat-Pak® creates the ideal sub-floor for carpet, linoleum, vinyl and cork etc.

Heat-Pak® is very simple to install and much quicker and easier to use than a traditional smoothing compound. It is also an entirely dry process so it is much cleaner and requires no setting time which allows the flooring to be laid immediately. Heat-Pak® makes the installation of electric cable, mat, foil or film systems far easier than using the wet screed method. Only small amounts of adhesive tape are required to hold the elements in position until the Heat-Pak® panels are laid on top ensuring that the entire heating system remains permanently flat and safely protected underneath the finished floor.

The very low thermal resistance of Heat-Pak® enables your valuable heat energy to pass quickly and easily through to the surface for a fast warm up time and maximum comfort. Heat-Pak® also provides for the inclusion of a suitable insulation layer below electric systems for optimum efficiency.

Heat-Pak® is composed of high quality MDF and the 3mm baseboards and 4mm topboards are each coated with a special interactive contact adhesive to give a strong, permanent full-surface bond. Strict quality controls during production guarantee excellent results and a trouble-free installation every time.

Specification

Size: 1200mm x 600mm

Top Board Thickness: 4mm

Base Board Thickness: 3mm

Composition: MDF, fitted with an interactive adhesive

Density (kg/m3): 770

Bending Strength kg/cm2: >40

Humidity (%): 4-10

Thermal Rm value [m2.K.W.-1]: 0.047

Fire Class, DIN4102: B2

Installation

Baseboard

Foam Tiles

Top Boards

Foam Tiles

Finish

Now you have installed the Warmup® Dual Overlay boards you can either glue your final floor finish to the boards as a final layer or simply lay it freely upon them. Before installing the final floor finish test the Warmup® foil heater(s) and floor sensor to ensure that no damage has occurred during the installation.

This method of installation will provide a stable surface for the floor finish to rest on and avoid any joints showing through the final floor finish. Now you have installed the Warmup® Dual Overlay boards you can either glue your final floor finish to the boards as a final layer or simply lay it freely upon them. Before installing the final floor finish test the Warmup® foil heater(s) and floor sensor to ensure that no damage has occurred during the installation.

Foam Tiles

For further Info or a quote call
07710 449159



Copyright © WarmHeat UK. All rights reserved.

Website Designed & Hosted by Richard Jenkins